燃煤MHD发电Cr25Al5电极材料的腐蚀行为研究

采用Ｃｒ＿（２５）Ａｌ＿５合金进行煤渣／种子条件下静态腐蚀试验（温度１３７３－１５７３ｋ，时间５０－１５０ｈｒ），试验后得出三种温度下腐蚀重量变化与腐蚀时间的关系，并借助金相显微镜、扫描电镜和俄歇分析进行有关形貌及成份分析，试验表明，温度是材料腐蚀的主要因素，在１４７３ｋ条件下材料的抗蚀性最好，Ａｌ、Ｓｉ元素在腐蚀过渡层中富集，Ｃｒ元素变化不大，但有从基体向外扩散的趋势。由此，这一材料若能进一步改进，可望在控制壁面温度的半热壁型通道中进行试验研究。     

具有Hammerstein形式的非线性系统广义预测控制

本文提出了具有Ｈａｍｍｅｒｓｔｅｉｎ形式的非线性系统广义预测控制方法，分析了当控制水平等于１时闭环系统的稳定性，同时还提出了使用线性估计器的非线性自适应广义预测控制算法。仿真结果表明了算法的有效性。     

空冷发电厂的热力设计与分析

本文对热力发电厂的汽轮机排汽冷却系统进行了评估。作者编制了计算机程序,并对海勒式空冷系统做了计算,结果显示了塔高、水流速与空气流量、冷却塔与散热器投资以及经济效益的关系。     

双臂协调约束系统动力学问题探讨

本文讨论了双臂协调约束系统的动力学问题．文中系统地描述了该系统的适应于计算机程序化的建模方法；推导了系统的动力学方程，并给出了用约束矩阵的正交补矩阵处理系统所受协调约束的方法；编制了相应的计算机辅助分析程序ＤＲＣＲＣＳ，并用该程序对算例进行了动力学的数值分析。     

Transient analysis of an advanced static var compensator using quad-series voltage-source PAM inverters

This paper deals with an advanced static Var compensator (ASVC) using quad-series voltage-source PAM inverters. The ASVC consists of four three-phase voltage-source inverters with a common dc capacitor and four three-phase transformers, each primary winding of which is connected in series with each other. Each inverter outputs a square-wave voltage, while the synthesized output voltage of the ASVC has a 24-step wave shape. This results not only in a great reduction of harmonic currents and dc voltage ripples but also in fewer switching and snubbing losses. In this paper, transient analysis is performed with the focus on the response of reactive power and the resonance between the dc capacitor and ac reactors. Experimental results obtained from a small-rated laboratory model of 10 kVA are also shown to verify analytical results based on the p-q transformation. The analytical results help in the design of system parameters such as the capacity of the dc capacitor and feedback gains.     

冷轧厂酸洗机组3号横剪大流量中高压液压系统设计方案探讨

在宝钢２０３０ｍｍ冷轧厂酸洗机组中，为了满足厚规格ＩＦ钢的生产，拟将原有的气动式剪切机改成液压式剪切机。为此，设计了一套中高压大流量的液压系统以满足３号横剪大剪切力（最高达７００ｋＮ）和快速剪切（３秒／次）的需要。由于采用了蓄能器增速回路和二通插装阀控制技术，使该液压系统较传统的剪切机液压系统具有响应速度快、体积小、重量轻、发热少和降低电机能耗等优点。     

小方坯连铸机的PLC自动控制

本文对弧型小方坯连铸机工艺与设备进行了分析，介绍了连铸生产的ＰＬＣ控制系统。及其软件设计。     

Fluidization of the active component of catalysts in catalytic formation of carbon assisted by iron and nickel carbides

A series of vanadium-tin mixed oxide catalysts have been prepared by the solid-state reaction of V₂O₅ and SnO₂ at 1250°C. The fresh and the used catalysts have been characterized by X-ray diffraction (XRD) and Fourier transform infrared spectroscopy (FTIR). High temperature oxygen chemisorption (HTOC) has been employed to titrate the coordinatively unsaturated vanadia sites. Ammoxidation of mesitylene has been carried out on these catalysts and an optimum composition of vanadium is arrived at. Better yields of tricyanobenzene (TCB) compared to literature values are obtained. A good correlation between the oxygen uptake and the TCB yield extends the applicability of HTOC to the fused oxide system.IICT Communication No. 3507.     

Onset of gas self-induction and power consumption after gas induction in an agitated tank

The behavior of inducted gas from liquid surface and the; power requirements in an agitated tank using a mechanical agitator are studied in order to increase the amount of gas self-induction and the gas retention time for gas absorption. A 45° six-blade downward impeller turbine was utilized in this study. Air and water, air and 40 wt% 60 wt%, and 80 wt% of glycerin water, and air and 106 cP silicon oil were employed as gas and liquid phases. Variables which were studied included geometrical factors (immersed depth of impeller, baffle with and diameter of impeller) and the physical properties of the liquid (viscosity, density, and surface tension). The correlations for the onset speed of impeller and power consumption after gas induction in the agitated tank are established from our experimental results. The amount of gas self-induction from the liquid surface in the agitated tank increases with increasing impeller diameter and speed and decreases with increasing baffle width, depth of impeller and viscosity of liquid.     

关于供排水管网的水力计算和校核

以往对电站技术供排水系统大都未进行水力平差计算，致使一些实际电站的供排水系统达不到预期的效果，甚至影响机组的正常运行。据此，给出了供排水管网的平差计算方法，有利于正确评估电站管网，另外，提出了管网校核应注意的问题。